Skip White Performance - We have the best prices you will ever find for aluminum heads, rotating assemblies and strokers
Skip White Performance
1910 Brookside Lane
Kingsport, TN 37660

M-F 8a-7p EST
Sat 10a-3p EST

5 star rating
260,500+ reviews!

 423-722-5152

ARP SBF Ford Head Bolts with Washers Hex Head ARP Part # 154-3601-FORD

$49.50

Available



Product Information

UPC351994845957
Product TypeShipped Product
Shipping Cost $0
Number of reviews 0
SBF FORD HEAD BOLT KIT WITH WASHERS ARP
# 154-3601-FORD

 photo 4c993495-e23a-4d0f-b754-780d86ea8890.jpg

File photo - Actual appearance may vary

Brand: ARP

Mfr. Part Number: 154-3601

Part Type: Cylinder Head Fasteners

Product Line: ARP High Performance Series Cylinder Head Bolt Kits

UPC: 672036003692

Fastener Style: Bolt

Undercut Stud: No

Head Style: Hex

Fastener Material: Chromoly

Fastener Finish: Black oxide

Washers Included: Yes

Cut to Fit: No

Quantity: Sold as a kit.

These ARP High Performance series head bolt kits are tough! They are rated at 170,000 psi, 15% stronger than Grade 8 fasteners.

INSTALLATION INSTRUCTIONS FROM ARP FOR HIGH PERFORMANCE SERIES HEAD BOLT KITS

180,000 PSI

7/16 inch Diameter

1. To ensure proper thread engagement and accurate torque readings, clean ALL threads in the block. Chase if necessary with ARP Thread Chaser.

2. Clean and inspect all hardware prior to installation. Look for obvious defects or shipping damages, plus proper fit, length and dimension.

3. Position the chamfered side of the washer on the bolt so it faces the bolt head. This is done to clear the radius on the under head of the bolt.

Note: Improper installation of the washer will cause premature bolt failure.

4. If the cylinder head bolts protrude into a water jacket, lubricate the threads of the bolts with ARP THREAD SEALER.

5. If the cylinder head bolts protrude into a blind hole, lubricate the threads of the bolts with ARP ULTRA-TORQUE FASTENER ASSEMBLY LUBRICANT.

6. Install the cylinder head(s) and check for binding or misalignment.

7. Lubricate the under head of the bolt and the washers with ARP ULTRA-TORQUE FASTENER ASSEMBLY LUBRICANT. Then install the bolts into the cylinder head and tighten them hand tight. ARP recommends using the ARP ULTRA-TORQUE FASTENER ASSEMBLY LUBRICANT that is provided with each kit as opposed to motor oil. This is due to higher friction on the bolts as well as inconsistencies in the clamping force of the fasteners when motor oil or other low quality lubricants are used.

PRELOAD (TORQUE) RECOMMENDATIONS

8. Following the manufacturer's recommended torque sequence tighten the bolts in three equal steps to 70 ft lbs with ARP ULTRA-TORQUE FASTENER ASSEMBLY LUBRICANT.


 photo f719e112-06ca-4bb0-b6ef-b904cd826b62.jpg


File Photo. Actual appearance may vary.


Customer Reviews

This product does not have any reviews yet.